INDENT BOBRICK B26637 SURFACE MOUNTED FOAM SOAP DISPENSER TRIMLINE SERIES SATIN STAINLESS

INDENT BOBRICK B26637 SURFACE MOUNTED FOAM SOAP DISPENSER TRIMLINE SERIES SATIN STAINLESS

BOBRICK B26637 FOAM SOAP DISPENSER
(SATIN STAINLESS 304)

MATERIAL:
Welded, 0.8mm (22 gauge) 1.4301, Typ CrNi 18/10, AISI 304 stainless steel housing with satin finish; stainless steel operating lever; metal lock and key; soap level indicator; interchangeable plastic containers with plastic pumps;variety of plastic containers available including containers with pumps for soap or foam.
OPERATION:
The cover is lockable with a Bobrick System lock. To refill the dispenser, open the cover by lifting and pulling forward. The soap level indicator shows how much product is remaining in the dispenser. The plastic container can be removed and re-installed for quick and easy refilling. The plastic container can be used for foam soap cartridges available in Europe (up to 1000 ml), as well as bulk refilling of up to 1000 ml of foam soap. To install a soap cartridge in the dispenser, open the cartridge and place it upside down inside the plastic container. Alternatively, soap can be poured directly into the plastic container. The dispenser has been designed for quick and easy refilling process.
INSTALLATION:
After opening the dispenser cover, remove the plastic container, gently lifting it upwards while pressing the locking latch. Mount the dispenser to the wall by using the enclosed screws and wall plugs. Make sure the wall surface is in good condition to ensure proper
mating of the dispenser to the wall. Use silicone or glue pads if necessary.
Note:
1. The dispenser should be installed near or directly above the sink to allow wet hands to drip into the sink.
2. Allow sufficient space above dispenser to exchange cartridges easily.
3. Recommended installation height: 100 – 110 cm (39" - 43") (measured from floor to the bottom of the dispenser).
TECHNICAL SPECIFICATIONS:
Model B-26637 from Bobrick Washroom Equipment, Dispenser made of 0.8 mm thick, (22 gauge) 1.4301, Type CrNi 18/10, AISI 304 stainless steel with a brushed, satin finish; plastic container for soap cartridges (up to 1000 ml), as well as for bulk refill of soap (up to 1000 ml); lockable with a Bobrick System lock; soap level indicator.

If you require assistance with your selection please contact us either by email or phone.

Fire.pngSupplied With Fixings
Capacity - 1000ml
Height- 336mm
Width - 96mm
Depth - 153mm
Made From Stainless Steel 304 Grade

Available Finish - Satin Stainless

FOR RELATED PRODUCTS REFER BOTTOM OF PAGE

Code Supplier Part Number Image Name Unit Function Finish Width Height Depth Capacity Mounting Notes Notes Price Quantity
BOB B26637 B26637 INDENT BOBRICK B26637 SURFACE MOUNTED FOAM SOAP DISPENSER TRIMLINE SERIES SATIN STAINLESS
  • Unit:
    Each
  • Function:
    Foam Soap Dispensers
  • Finish:
    Satin Stainless
  • Width:
    96mm
  • Height:
    336mm
  • Depth:
    153mm
  • Capacity:
    1ltr
  • Mounting:
    Surface Mount
  • Notes:
    Indent Product Check Delivery
Each Foam Soap Dispensers Satin Stainless 96mm 336mm 153mm 1ltr Surface Mount Indent Product Check Delivery Indent Product Check Delivery
$804.55 (exc GST)